Ricebubbles at 11:17, 19 March 2015

2015-03-19T11:17:18Z

← Older revision		Revision as of 11:17, 19 March 2015
Line 1:		Line 1:
	~~'''~~Steering Column ~~Height~~ Easy Entry/Exit ~~Issues'''~~		==Description - Steering Column Adjustment==
			Edit required.

			==Issues - Steering Column Adjustment==
			===Easy Entry/Exit Feature - Steering Column Adjustment===
	* If the Steering Column Height Easy Entry/Exit feature does not work, then resetting, normalisation or calibration may be required.		* If the Steering Column Height Easy Entry/Exit feature does not work, then resetting, normalisation or calibration may be required.
	* The Steering Column Height Easy Entry/Exit feature requires resetting, following a voltage supply interruption or malfunction, eg after removing the battery terminals.		* The Steering Column Height Easy Entry/Exit feature requires resetting, following a voltage supply interruption or malfunction, eg after removing the battery terminals.
			===Malfunction - Steering Column Adjustment===
	* If the steering column will not move at all, it is either a broken nylon connector inside the column, a bad motor, or a fuse problem.		* If the steering column will not move at all, it is either a broken nylon connector inside the column, a bad motor, or a fuse problem.
	* If you can move your steering column down SLIGHTLY, and then bring it back up to where it started, but not higher, then resetting may be required.		* If you can move your steering column down SLIGHTLY, and then bring it back up to where it started, but not higher, then resetting may be required.
	* '''CAUTION''', if the steering column goes down slightly, but will not go back up at all, do not try the reset - the steering column could go fully down and not come back up! Then you may not be able to get into the car to drive. If that happens. Get it serviced.		* '''CAUTION''', if the steering column goes down slightly, but will not go back up at all, do not try the reset - the steering column could go fully down and not come back up! Then you may not be able to get into the car to drive. If that happens. Get it serviced.

	~~'''Reset~~ Steering Column ~~Height~~ Easy Entry/Exit~~'''~~		==DIY Procedures - Steering Column Adjustment==
			===Reset - Easy Entry/Exit Feature===
	This ~~how to~~ guide resets the limit positions for the Hall Effect Sensors in the Steering Column, and your Column should then function normally.		This DIY guide resets the limit positions for the Hall Effect Sensors in the Steering Column, and your Column should then function normally.
	* Resetting is basically the same procedure as for the Electric Side Windows, etc., but with the '''caution''' referred to above.		* Resetting is basically the same procedure as for the Electric Side Windows, etc., but with the '''caution''' referred to above.
	* Move the steering column fully down, and hold the switch for about 10 seconds after it reaches the lowest position.		* Move the steering column fully down, and hold the switch for about 10 seconds after it reaches the lowest position.
	* Then run the steering column back up fully and hold the switch up for about 10 seconds after the column reaches its upper limit of travel.		* Then run the steering column back up fully and hold the switch up for about 10 seconds after the column reaches its upper limit of travel.
	* Note you may need to do this several times.		* Note you may need to do this several times.

Ricebubbles: Started adding detail for WIS 46.15 Steering Column Adjustment.

2015-03-11T03:55:17Z

Started adding detail for WIS 46.15 Steering Column Adjustment.

New page

'''Steering Column Height Easy Entry/Exit Issues'''
* If the Steering Column Height Easy Entry/Exit feature does not work, then resetting, normalisation or calibration may be required.
* The Steering Column Height Easy Entry/Exit feature requires resetting, following a voltage supply interruption or malfunction, eg after removing the battery terminals.
* If the steering column will not move at all, it is either a broken nylon connector inside the column, a bad motor, or a fuse problem.
* If you can move your steering column down SLIGHTLY, and then bring it back up to where it started, but not higher, then resetting may be required.
* '''CAUTION''', if the steering column goes down slightly, but will not go back up at all, do not try the reset - the steering column could go fully down and not come back up! Then you may not be able to get into the car to drive. If that happens. Get it serviced.

'''Reset Steering Column Height Easy Entry/Exit'''

This how to guide resets the limit positions for the Hall Effect Sensors in the Steering Column, and your Column should then function normally.
* Resetting is basically the same procedure as for the Electric Side Windows, etc., but with the '''caution''' referred to above.
* Move the steering column fully down, and hold the switch for about 10 seconds after it reaches the lowest position.
* Then run the steering column back up fully and hold the switch up for about 10 seconds after the column reaches its upper limit of travel.
* Note you may need to do this several times.

WIS 46.15 Steering Column Adjustment - Revision history

Ricebubbles at 11:17, 19 March 2015

Ricebubbles: Started adding detail for WIS 46.15 Steering Column Adjustment.