Rear doors

Remove/install door lining on rear door

1 - Trim strip 2 - Door control unit covering 3 - Door handle cover 4 - Door lining 5 - Mounting wedge 6 - Bolt 7 - Lock trim surround 8 - Inner door panel 9 - Clip retainer 10 - Bolt 11 - Bolt 12 - Cover 13 - Bolt

1 - Trim strip 2 - Door control unit covering 15 - Bolts

2 - Door control unit covering N69/3 - Left rear door control unit N69/4 - Right rear door control unit

1. Press trim strip (1) off of door control module covering (2) with mounting wedges (5).
2. Remove door handle cover (3) from door handle
3. Unscrew bolts (15) and press door control module covering (2) out of door lining (4) with mounting wedges (5) and remove
4. Disconnect connectors from left rear door control module (N69/3) and right door control module (N69/4) and remove door control module covering (2)
5. Unscrew bolt (6) from lock cover plate (7) and remove lock trim surround (7).
6. Remove cover (12) and unscrew bolt (13)
7. Press door lining (4) off of inner door panel (8) with mounting wedges (5). Move mounting wedges (5) directly to clip retainer (9) so that the retainer tab of the clip retainer do not tear out off the door lining.
8. Pry door lining (4) out of retaining clamps on at top of sealing rail with mounting wedges (5) and simultaneously remove from inner door panel.
9. Unhook control cable from inside door opener.
10. Disconnect electrical connectors from door lining (4) and lay down door lining (4).
11. Check insulating mat and clip retainers (9). Replace damaged insulating mat and clip retainers.
12. Install in the reverse order. Installation:Remove clip retainers still on inner door panel (9) and install at corresponding point on door lining.

Load video YouTube YouTube might collect personal data. Privacy Policy ContinueDismiss Rear door panel removal.

Rear door lining removed.