Bumpers

From W220 S-Class Encyclopedia
Revision as of 11:04, 8 August 2017 by Pokseva (talk | contribs) (instruction for removing bumper)
Jump to navigation Jump to search

Remove/install front bumper

  • 1 - Bumper
  • 1 A - Foam insert
  • 1 B - Retaining plate
  • 2 - Bolt
  • 3 - Nut
  • 11 - Antenna line
  • 4 - Air inlet grille
  • 5 - Bracket
  • 6 - Bolt
  • 7 - Retaining bracket
  • B14 - Outside temperature display temperature sensor
  • X26/27 - Front bumper PTS connector
  1. Expose antenna line (11) for TV antenna
  2. Electrical plug socket in left fuse box. Installation: Install new tie straps.
  3. Engine 112, 113, 137, 275:
    1. Remove bottom engine compartment paneling. Only remove front part.
  4. Engine 613, 628, 648:
    1. Remove bottom part of noise encapsulation. Only remove front part.
  5. Pull outside temperature display temperature sensor (B14) out of bumper
  6. Unlock and separate front bumper PTS connector (X26/27). To unlock, pivot lock flap in direction of arrow.
  7. Remove fender liner from front fender. Remove only front section of fender liner.
  8. Unscrew bolt (6)
  9. Pivot retaining bracket (7) toward center of vehicle, pull out to rear and remove
  10. Unscrew bolt (2)
  11. Unclip air inlet grate (4). Do not damage paint.
  12. Unscrew nuts (3).
  13. Remove bumper (1) toward front. Installation: Ensure that retainer tabs on rear bumper (1) are pushed behind bracket (5).
  14. Install in the reverse order

Bumper Strip Removal

Load video
YouTube
W220 bumper strip front removal.
Load video
YouTube
W220 bumper strip rear removal.

Facelift Model Bumpers

Front Center Lower Grille

Part number A2208851523.

A2208851523 front.
A2208851523 back.
A2208851523 side.

Pre-facelift

Retrieved from "https://w220.wiki/index.php?title=Bumpers&oldid=6427"