Press trim strip (1) off of door control module covering (2) with mounting wedges (5).
Remove door handle cover (3) from door handle
Unscrew bolts (15) and press door control module covering (2) out of door lining (4) with mounting wedges (5) and remove
Disconnect connectors from left rear door control module (N69/3) and right door control module (N69/4) and remove door control module covering (2)
Unscrew bolt (6) from lock cover plate (7) and remove lock trim surround (7).
Remove cover (12) and unscrew bolt (13)
Press door lining (4) off of inner door panel (8) with mounting wedges (5). Move mounting wedges (5) directly to clip retainer (9) so that the retainer tab of the clip retainer do not tear out off the door lining.
Pry door lining (4) out of retaining clamps on at top of sealing rail with mounting wedges (5) and simultaneously remove from inner door panel.
Unhook control cable from inside door opener.
Disconnect electrical connectors from door lining (4) and lay down door lining (4).
Check insulating mat and clip retainers (9). Replace damaged insulating mat and clip retainers.
Install in the reverse order. Installation:Remove clip retainers still on inner door panel (9) and install at corresponding point on door lining.
