Doors
Handles
 |
 |
| Part No. | Notes |
|---|---|
| A2207601170 | Left (front/rear) |
| A2207601270 | Right (front/rear) |
| A2207601370 | Left (front/rear). For vehicles with option code 889 (KEYLESS-GO). |
| A2207601470 | Right (front/rear). For vehicles with option code 889 (KEYLESS-GO). |
The W215 has exactly the same door handles with the only difference that KEYLESS-GO handle has opposite connector (male instead of female) .
 |
 |
KEYLESS-GO rubber button
After years of wear the rubber on KEYLESS-GO button develops cracks and allows water to get in. Moisture in turn can lead to damage of the microswitch.
Aftermarket replacement rubber buttons can be bought on ebay for EUR 40 per pair. The residues of the old rubber have to be removed and the new button glued in.
If the KEYLESS-GO microswitch is also damaged, the easiest solution is to buy used handle and repaint it.
 |
 |
 |
Chrome
With time the chrome layer of door handle develops bubbles and starts to peal off. The chrome part is not sold separately, but can be replace from another handle. The chrome on KEYLESS-GO door handles can be easily removed by unscrewing two screws. The chrome on door handle without KEYLESS-GO button can be pulled of by carefully prying it off from the inner side of door handle.
Door pillar panel covers
| Part No. | Notes |
|---|---|
| A2206900787 (~ EUR 50) | Front left |
| A2206900887 (~ EUR 50) | Front right |
| A2206901187 (~ EUR 50) | Rear left |
| A2206901287 (~ EUR 50) | Rear right |
The covers are held in place by an extremely strong tape that is already on the replacement parts. One must thoroughly clean the old tape residue off, or it will interfere with a proper mount - it can hold the new part too far out. Care must be exercised in positioning the new parts.
 |
 |
 |
There are aftermarket carbon covers available on ebay, however, these covers come without plastic top ending.
Door Handle Latch Mechanism
Issues
- Inner handle is too loose and will not pull the latch mechanism far enough forward to release the latch.
- There is no tension adjustment for the cable.
- The cable slips out of the guide very easily as you move the inner door cover away from the door.
- A common fault is improper positioning of the cable in the inner handle mechanism.
Solution
At the back of the door handle mechanism there is a "Guide" - the inner part of the cable must be threaded into the guide (1 in the photo), and the cable jacket fitted into a small receptacle (at 2).
With that done, the cable is positioned properly, the tension is correct, the door handle operates the latch, and springs back to the proper position when released.