Tail lights: Difference between revisions
Jump to navigation
Jump to search
(→LED board: added A2208200311 DEPO image) |
(→DEPO: added images of labels on the DEPO tail light lens) |
||
| Line 21: | Line 21: | ||
=== DEPO === | === DEPO === | ||
[[File:W220_taillight_facelift_depo.jpg|300px]] | {| | ||
|[[File:W220_taillight_facelift_depo.jpg|300px]] | |||
|[[File:W220_DEPO_left_taillight_label.jpg|thumb|none|Label on the left lens reads "DEPO 01-440-1919L-R".]] | |||
|[[File:W220_DEPO_right_taillight_label.jpg|thumb|none|Label on the right lens reads "DEPO 01-440-1919R-R".]] | |||
|} | |||
'''Note:''' DEPO taillight should not be mixed with original facelift taillights, since DEPO taillight is a bit lighter (see below). | '''Note:''' DEPO taillight should not be mixed with the original facelift taillights, since DEPO taillight is a bit lighter (see below). | ||
[[File:W220_taillights_DEPO_left_Original_right.jpg|thumb|none|DEPO on the left, original facelift taillight on the right.]] | [[File:W220_taillights_DEPO_left_Original_right.jpg|thumb|none|DEPO on the left, original facelift taillight on the right.]] | ||
=== W221 Style === | === W221 Style === | ||
Revision as of 03:11, 4 April 2015
Back to: WIS 82.10 Exterior Lights
Location – Tail Lights
Facelift (after 30/09/2002)
A2208200764 - tail lamp left A2208200864 - tail lamp right
Pre-facelift (before 01/09/2002)
A2208200164 - tail lamp left A2208200264 - tail lamp right
Aftermarket
DEPO
|
 |
 |
Note: DEPO taillight should not be mixed with the original facelift taillights, since DEPO taillight is a bit lighter (see below).
W221 Style
Removing
- Open your trunk and take the cover out.
- There are four screws, remove them (see below).
LED board
For the break light W220 taillights use LED board.
A2208200411 - right
A2208200311 - left
There seem to be two versions of LED boards. V2.2 which has square LED bulbs and V2.5/V2.6 which has round LED bulbs.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Replacing LED bulbs
The whole LED board unit is expensive. LED bulbs can be replaced by soldering.
- Remove the taillight from vehicle.
- Take the circuit board out, it is attached by one screw (see below).
- Use a 12v adapter by connecting it to the circuit board and see which bulbs are damaged.
- Remove damaged bulbs and install new ones using a soldering iron. Make sure the new led lights are positioned the same exact way the old ones were, otherwise they will not work.
- Once this is done, you can insert the circuit board back into the car. Make sure prior to this all the lights are working.
You can buy square LED bulbs by using this keyword "LED 7.62MM 638NM ALINGAP RED CLR - LTL912SEKSA".
Washer
