Removing and installing front floor covering (right)

Removing and installing front floor covering (right)

1 - Edge guard 2 - Door sill molding 3 - Clip 4 - Panel 5 - Clip 6 - Cap 7 - Screw 8 - Floor covering

1. Move front seat back as far as possible
2. Remove cover below instrument panel (right). (No need to remove in practice.)
3. Pull off door sill molding (2). Door sill molding fastened with 3 clips.
4. Pull off edge guard (1) in lower area on A-pillar
5. Remove panel (4). Fastened with 2 clips in addition.
6. Lift floor covering (8) at rear, remove at center console and then remove towards rear. Installation: Insert floor covering (8) in area of center console (arrows).
7. Install in opposite order

Door still molding removed.

Side panel.

Floor covering removed.