Auxiliary battery: Difference between revisions
(Created page with "This page shows how to install auxiliary battery in W220. == Battery == For auxiliary battery it is better to not use starter battery (e.g. most automotive batteries), but a...") |
(language) |
||
| Line 1: | Line 1: | ||
This page shows how to install auxiliary battery | This page shows how to install auxiliary battery and connect it to the charging system. | ||
Auxiliary battery is useful to power a coolbox/fridge or set up a 24/7 surveillance system | |||
without worrying about the starter battery being drained while the engine is not running. | |||
== Battery == | == Battery == | ||
For auxiliary battery it is better to not use starter battery (e.g. most automotive batteries), | For auxiliary battery it is better to not use a starter battery (e.g. most automotive batteries), | ||
but a [https://en.wikipedia.org/wiki/Deep_cycle_battery deep-cycle] battery that is designed to be regularly deeply discharged using most of its capacity. | but a [https://en.wikipedia.org/wiki/Deep_cycle_battery deep-cycle] battery that is designed to be regularly deeply discharged using most of its capacity. | ||
| Line 19: | Line 21: | ||
== Installation == | == Installation == | ||
Battery fits tight in the left side of the trunk. For better fit wrap it | Battery fits tight in the left side of the trunk. For better fit wrap around it solid rubber sheets. | ||
To put back the electronics bracket, it has to be cut below the navigation device level. | To put back the electronics bracket, it has to be cut below the navigation device level. | ||
[[MOST Audio Gateway|Audio gateway]] which was below the [[MOST Navigation|navigation unit]] can be attached to the navigation unit with cable ties as shown in the picture. | [[MOST Audio Gateway|Audio gateway]] which was below the [[MOST Navigation|navigation unit]] can be attached to the navigation unit with cable ties as shown in the picture. | ||
If [[MOST CD Changer|CD Changer]] is used, the space for it has to be found somewhere else. | If [[MOST CD Changer|CD Changer]] is used, the space for it has to be found somewhere else. | ||
Since the lower of | Since the lower part of electronics bracket is cut off, the bracket now is attached only by 2 screws instead of 3. | ||
screws instead of 3 | However, the installation is pretty tight anyway and unless the W220 is thrown on its roof the battery will not move in its place. | ||
Note that since the left side of the trunk is not square, two outer corners of the the battery will deform a bit the chassis (as can be seen in the picture below). | |||
{| | {| | ||
Revision as of 23:08, 27 December 2015
This page shows how to install auxiliary battery and connect it to the charging system. Auxiliary battery is useful to power a coolbox/fridge or set up a 24/7 surveillance system without worrying about the starter battery being drained while the engine is not running.
Battery
For auxiliary battery it is better to not use a starter battery (e.g. most automotive batteries), but a deep-cycle battery that is designed to be regularly deeply discharged using most of its capacity.
Crown 27DC115 (EUR 200) is battery that perfectly fits in the left side of W220 trunk.
Specification:
|
 |
Installation
Battery fits tight in the left side of the trunk. For better fit wrap around it solid rubber sheets. To put back the electronics bracket, it has to be cut below the navigation device level. Audio gateway which was below the navigation unit can be attached to the navigation unit with cable ties as shown in the picture. If CD Changer is used, the space for it has to be found somewhere else. Since the lower part of electronics bracket is cut off, the bracket now is attached only by 2 screws instead of 3. However, the installation is pretty tight anyway and unless the W220 is thrown on its roof the battery will not move in its place. Note that since the left side of the trunk is not square, two outer corners of the the battery will deform a bit the chassis (as can be seen in the picture below).
 |
 |
 |
Charging
We want the auxiliary battery to be isolated from the main circuit when the car is off (to not drain the auxiliary battery and vice versa), but to connect it to the main circuit when the car is running so that alternator would charge both the starter battery and the auxiliary battery. To do this automatically the starter battery's positive terminal and auxiliary battery's positive terminals must be connected together (using wires at least 3mm in thickness) by high current (200A) relay (EUR 10). The negative terminal of auxiliary battery can be permanently attached to the chassis. The relay should be activated by positive 12-volt wire from alternator's D+ terminal (warning lamp wire). This will make sure that auxiliary battery is connected to the main circuit only when the alternator is already producing the output. The optimal place to install the relay is to put it under the rear seat and attach it to the electronics bracket. The wire from engine bay can be passed to right footwell through the right fuse box and then to the rear seat consulting rear view camera wiring guide.
 |
 |
 |
Original Auxiliary Battery
A second battery fitted on the right-hand side of the trunk above the existing battery is an optional extra in Europe. It is clearly shown in WIS/ASRA under AN54.10-P-00021 and requires a new battery holder, circuit breaker and new modified trunk paneling for the right-hand side.