Bumpers: Difference between revisions

Revision as of 17:11, 29 August 2017

Expose antenna line (11) for TV antenna
Electrical plug socket in left fuse box. Installation: Install new tie straps.
Engine 112, 113, 137, 275:
1. Remove bottom engine compartment paneling. Only remove front part.
Engine 613, 628, 648:
1. Remove bottom part of noise encapsulation. Only remove front part.
Pull outside temperature display temperature sensor (B14) out of bumper
Unlock and separate front bumper PTS connector (X26/27). To unlock, pivot lock flap in direction of arrow.
Remove fender liner from front fender. Remove only front section of fender liner.
Unscrew bolt (6)
Pivot retaining bracket (7) toward center of vehicle, pull out to rear and remove
Unscrew bolt (2)
Unclip air inlet grate (4). Do not damage paint.
Unscrew nuts (3).
Remove bumper (1) toward front. Installation: Ensure that retainer tabs on rear bumper (1) are pushed behind bracket (5).
Install in the reverse order

W220 bumper strip front removal.

W220 bumper strip rear removal.

Part number A2208851523.

@@ Line 44: / Line 44: @@
 # Remove bumper (1) toward front. Installation: Ensure that retainer tabs on rear bumper (1) are pushed behind bracket (5).
 # Install in the reverse order
+{|
+|[[File:W220_temperature_sensor_inside_bumper.jpg|thumb|none|Outside temperature sensor (B14).]]
+|[[File:W220_temperature_sensor_removed.jpg|thumb|none|Sensor unplugged.]]
+|[[File:W220_temperature_sensor_bumper_hole.jpg|thumb|none|Sensor hole in the left bumper grille ([[facelift]]).]]
+|}
+{|
+|[[File:W220_bumper_fender_screw.jpg|thumb|none|Screw holding retaining bracket.]]
+|[[File:W220_bumper_fender_retaining_bracket_look_from_inside.jpg|thumb|none|Look from right headlamp area.]]
+|[[File:W220_bumper_fender_retaining_bracket_removed.jpg|thumb|none|Retaining bracket removed.]]
+|}
+[[File:W220_bumper_fender_detached.jpg|thumb|none|Bumper detached from fender.]]
 ==Bumper Strip Removal==