Car Solutions RGB-LE-V3.1

Description

Price: USD 190.

Installation

Remove the COMAND from the vehicle using COMAND removal instructions.

Unscrew 2 chassis cover screws at top of radio.

Unscrew 4 on the rear of the unit, remove cover from top of unit.

Begin by unscrewing the disc mechanism from the unit. There are 2 screws holding it in place.

Unscrew the mechanism's other mounting screw.

Loosen the ribbon cable attachment clip with a small screwdriver and carefully remove the entire disc mechanism.

Continue removing the remaining screws to remove the board.

Using needle nosed pliers twist the metal clip that attaches to the board.

Using a small screwdriver unscrew the ribbon cable from the board.

Unclip the plastic connector from both sides.

Disconnect ribbon cable from the board.

Leave the ribbon cable disconnected.

Using the supplied ribbon cable extender, connect the existing ribbon cable to the extended cable.

Connect the supplied 2nd ribbon cable to the board, lock clips in place.

Connect ribbon cables to the interface board as shown above.

Reassemble the head unit.

Connect RGB cable and run outside of unit.

Disconnect the wires from the connector to pull the cable through the hole.

Mount converter on top of radio with 2 sided tape.