Starter
Back to Index
Parts
12 V/1.7 kW
Starter relay
Remove starter, install
Valid for:
- ENGINE 112.922 in MODEL 220.063 (S280)
- ENGINE 112.944 in MODEL 220.065/165 (S320, except S320 CDI)
- ENGINE 113.941 in MODEL 220.070/170 (S430, except S430 4Matic)
- ENGINE 113.960 in MODEL 220.075/175/875 (S500, except S500 4Matic)
- ENGINE 112.972 in MODEL 220.067/167 (S350, except S350 4Matic)
|
|
- Turn key in electronic ignition lock EIS into position "0". Key cannot be withdrawn.
- Dismount ground line to the battery.
- Detach lower engine compartment paneling.
- Unscrew bolts (3)
- Unscrew nuts (4) and remove electrical lines (1, 2).
- Take starter (M1) down and out
- When replacing the starter check ring gear on the drive plate for wear and damage. Rotate engine at the crankshaft in direction of rotation.
- Install in the reverse order
- Render electrical system operational
- Read diagnostic trouble code memory and erase
Torque specification:
- Nut of connection of circuit 30 - Nm 14.
- Nut of connection circuit 50 - Nm 6.
- Bolt of starter to crankcase - Nm 42.
Removal/installation on S350
Starter is attached to transmission and crankcase with two E14 torx bolts. Starter can be removed from underneath the vehicle - only plastic shields have to be removed. Since there is not much space the process is not very convenient but is possible.
 |
 |
 |
 |
 |
 |
 |
 |