Transmission Detailed DIY Flushing System Design

Back to WIS 27.00 Transmission - General

DIY Transmission Flushing System - Description

This DIY Transmission Flushing System was constructed using parts which are readily available from any hardware store. A transmission in-line connector and pipes was obtained from a wrecked M-B.

A parts list is:

• two off 5L garden spray pump pressure bottles,
• rubber tubing,
• reinforced vinyl tubing,
• brass coupling fittings,
• hose clamps,
• aftermarket in-line transmission fluid filter, and
• a used in-line transmission connector and pipes.

The in-line connector and pipes from the wrecked M-B were cut and fitted to the clear vinyl tubing and became the connection points to the vehicle being serviced.

DIY Transmission Flushing System with 722.9 NAG2 7G-Tronic Connectors

DIY Transmission Flushing System - Connection to Vehicle

During the service procedure it is simply a matter of opening the in-line connector in the transmission cooling supply line at the lower left corner of the radiator and connecting in the DIY Flushing System.

DIY Transmission Flushing System - In Use

Note new red fluid and old dark fluid in the clear vinyl tubing lines.

The exact procedure is described here. Yet to be added.