Rear axle
Back to: WIS 32.00 General
Identification - Rear Drive/Axle Suspension
Components - Rear Drive/Axle Suspension
Lower Bushing - Rear Drive/Axle Suspension
The Lower Rear Axle Suspension Bushing, item (17) and item (10) below, is located at the strut supporting joint in the wheel carrier.
Designations - Rear Axle Suspension
Issues - Rear Suspension
- Squeaking, creaking noises from the rear suspension is a common problem.
- The axial ball joints that look like bushings lose their internal lubrication.
There is one at the bottom of each suspension strut and another one at the back of the wheel spider. Four of them in total. There is no part number for the bottom strut ones but they are the same as the outer ones.
It is recommend to replace both the strut one and the outer one when during replacement.
Parts - Rear Suspension
- M-B: A2203520027.
- TRW: JBU167.
Tools - Rear Suspension
- To remove and replace the bushing a special tool is needed.
- Removal and Installation Tool W202589004300 (see Special Tools page).
DIY Tasks - Rear Suspension
Lower Bushes - Temporary Fix
A quick temporary fix is to make a slit in the rubber seal and inject some oil.
Lower Bushes - Rear Suspension DIY Replacement
Reference: WIS AR32.25-P-1871M Replace rubber mounts of rear shock absorbers
Designations -Rear Shock Absorbers
Removal -Rear Shock Absorbers Rubber Bushes
- Empty suspension strut (4) of rear axle using STAR DIAGNOSIS.
- Partially remove spring control arm (1). TIP: Unhook exhaust system on both rear exhaust-rubber mounts. TIP: Detach spring control arm from rear axle carrier and swing downwards.
- Remove rubber mounts (2) using extraction and insertion tool (01). AIRmatic Lower Rubber Bushes - Rear Suspension
- Clean and check bearing seat (3).
Installation -Rear Shock Absorbers Rubber Bushes
- Install rubber mounts (2) using extraction and insertion tool (01). TIP: Do not squeeze plastic parts (large arrow) of the rubber mount (2). Cracked plastic parts result in corrosion and thus to damage to the rubber mount(2).
- Check installation position of the rubber mount (2). TIP: Carry out visual inspection of distances (small arrows) from outer bearing shell collar (2b) to the bearing seat edge (3k). In the event of unequal distances (small arrows) correct the installation position using the extraction and insertion tool (01).
- Install spring control arm (1). TIP:Unhook exhaust system on both rear exhaust-rubber mounts.
- Fill the suspension strut (4) using STAR DIAGNOSIS. TIP: The wheels must not touch the ground while pressurizing because the air spring bellows in the suspension strut (4) will be destroyed if pressurized with the suspension compressed.
- Check AIRmatic for leaks.
Resources - Rear Suspension
http://www.benzworld.org/forums/w210-e-class/1602887-diy-r-r-outer-bushing-rear.html
http://www.benzworld.org/forums/w201-190-class/1673624-worn-out-hub-carrier-bushing-3.html
http://www.benzworld.org/forums/w220-s-class/1623753-loud-creaking-rear-03-w220-4matic.html
http://www.benzworld.org/forums/w220-s-class/1695182-w220-04-s600-abc-issue-squeaking.html
How to change subframe bushes: http://forums.mercedesclub.org.uk/showthread.php?t=90826 and http://forums.mercedesclub.org.uk/showthread.php?t=90827 .